It is a kind of refrigeration mechanical equipment that cools water through an evaporator and is cooled by the refrigerant of the refrigeration system to generate ice. The refrigeration system is used, and the water carrier is used to make ice after passing through a certain equipment in an electrified state. Then the editor of the ice maker manufacturer below will tell you how to use the ice maker? And what are the precautions for use, welcome to read!

How to use the ice maker?

1. Check whether the various devices of the ice maker are normal before use, for example, whether the water supply device is normal, and whether the water in the water tank is normal (there are water tanks that have been set at the factory).

2. After the ice maker works normally, place the ice maker in a stable position, and insert the prepared bottled water into the water inlet of the ice maker. At this time, the sea water will automatically enter the water tank of the ice machine.

3. After the ice maker is plugged into the power supply, the ice maker starts to work, and the water pump is sent from the water tank to the ice making area. At the beginning, the ice maker has a process of discharging air. After the air is exhausted, it is compressed. The machine starts to start and enters the working state, and the ice maker starts to enter the ice making state.

4. When the ice thickness in the ice maker reaches the thickness set by the ice maker, the ice plate probe in the ice maker starts to work. When the defrosting solenoid valve works, the water pump stops working, the hot air enters the evaporator, and the ice cubes start to work. decline.

5. When the ice cubes start to fall, flip the baffle and turn on the reed switch. When a certain amount of ice cubes is reached, the magnetic reed will be closed again, and the ice maker will enter the ice making state again.

6. When the ice storage bucket of the ice maker is full of ice, the reed switch will not automatically turn off, the ice maker will automatically stop working, and the ice making is completed. For example, turn off the power switch of the ice maker, unplug the ice maker, and the ice making ends.

Notes on using the ice maker:

1. The ice maker should be installed in a place far away from the heat source, avoid direct sunlight, and in a well-ventilated place, and the ambient temperature should not exceed 35 °C, so as to avoid excessive heat dissipation of the condenser and affect the ice-making effect. The floor of the ice maker should be flat and level, and the ice maker must be kept level, otherwise it will cause no ice removal and running noise.

2. The gap between the back and the left and right sides of the ice maker is not less than 30cm, and the top gap is not less than 60cm.

3. The ice maker should be powered by an independent power supply, a dedicated line, and be equipped with fuses and leakage protection switches, and should be reliably grounded.

4. The water used by the ice maker should meet the national drinking water standards, and a water filter device should be installed to filter impurities in the water, so as not to block the water pipe and pollute the pool and ice mold. Affects ice making performance.

5. When cleaning the ice machine, the power supply should be turned off. It is strictly forbidden to use the water pipe to wash the body directly, and use neutral detergent to scrub, and it is strictly forbidden to use acidic, alkaline or corrosive solvents for cleaning.

6. The ice maker needs to be screwed into the water hose head for two months to clean the filter screen of the water inlet valve to prevent the sand and mud impurities in the water from clogging the water inlet, which will cause the water inlet to become smaller, resulting in no ice making.

Thank you for reading, the above is how to use the ice maker? What are the precautions for use? The introduction, part of the content comes from the Internet, for reference only. If you want to know more about the details of the ice maker manufacturer, please call for details and serve you wholeheartedly.